Page 1 of 1

Eliminating hr_recovery data from fit-files

PostPosted: Mon Oct 01, 2018 2:00 pm
by Frieder Tonn
Hello OMB,

I have an Forerunner 735XT for running and biking.
When I run with HR-Sensor and I make a break for about 1-2 minutes, a message "HR Recovery detected" appears on my forerunner-display.
This message is also stored as an EVENT_MESG (event=21, event_type=3, event_data=hr_recovery) in the fit-fileformat.
Sporttracks can not use this MESG in a right way and the HR-table in Sporttracks goes wrong.
So I have to edit the *.logbook manualy an kill these lines using an texteditor.

My question is:
It's possible to add a function to "After Import" so that this message will be ignored in the future?
If it is nessesary, I will give you some examples.

Thanks and regards,
Frieder

Re: Eliminating hr_recovery data from fit-files

PostPosted: Mon Oct 01, 2018 2:08 pm
by old_man_biking
Frieder Tonn wrote:Hello OMB,

I have an Forerunner 735XT for running and biking.
When I run with HR-Sensor and I make a break for about 1-2 minutes, a message "HR Recovery detected" appears on my forerunner-display.
This message is also stored as an EVENT_MESG (event=21, event_type=3, event_data=hr_recovery) in the fit-fileformat.
Sporttracks can not use this MESG in a right way and the HR-table in Sporttracks goes wrong.
So I have to edit the *.logbook manualy an kill these lines using an texteditor.

My question is:
It's possible to add a function to "After Import" so that this message will be ignored in the future?
If it is nessesary, I will give you some examples.

Thanks and regards,
Frieder

Hi Frieder,

sorry, but I've stopped adding new features to my plugins.

Cheers,
OMB

Re: Eliminating hr_recovery data from fit-files

PostPosted: Tue Oct 02, 2018 12:46 am
by Frieder Tonn
O.K., Thanks.